Siemens SIMATIC ET 200S Manual page 540

RESERVE modules
• Configure the interface module as follows:
Operation at Preset <> Actual
configuration
• If you have configured an electronic module with inputs for the RESERVE
module, the following substitute values are reported:
-- Digital Input Modules: 0
-- Analog Input Modules: 7FFF
-- Function Module: 0
Note
If you use the RESERVE module,
the SF LED lights up on the interface module
•
a channel-related diagnosis and module status "10
•
returned for that slot of the RESERVE module.
For the functioning and configuration with option handling see Chapter 3.8.
Terminal assignment
The RESERVE module is not connected to the terminals of the TM-E terminal
module. This means that the TM-E terminal module can be fully wired and
prepared for the future application.
Technical data
Dimensions and weight
Dimensions
W x H x D (mm)
Weight
Voltages, currents, electrical potentials
Power loss of the
module
14-2
Parameters
15 x 81 x 52
30 x 81 x 52
approx. 33 g
(installation width
15 mm)
approx. 55g (installation
width 30 mm)
Typically 0.025 W
Setting
enabled
H
B
Status, Interrupts, Diagnostics
Status display
Diagnostic functions
: incorrect module" is
No
No
ET 200S Distributed I/O System
EWA-4NEB 780602402-12