Siemens SIMATIC ET 200S Manual page 562

Address Space of the Input and Outputs of the ET 200S
Table C-1
4 IQ-SENSE (standard)
4 IQ-SENSE (Enhanced)
ET 200S FC frequency
converter
1)
See Section 6.1.1 (Configuring the ET 200S on the PROFIBUS DP)
2)
Additional optional entries you can select from the DBB file
Address area for option handling and status byte
You can control and monitor option handling, and evaluate the status byte of the
power module using the control (PIQ) and feedback interface (PII).
The address range of the control (PIQ) and feedback interface (PII) depends on
the configuration or selection of the corresponding entry in the configuration
software.
In STEP 7, HWCONFIG
or COM PROFIBUS or
other configuration
Usual entry for the
Power module
Ends in ...S
Ends in ...O
Ends in ...SO
C-2
Inputs and outputs for the ET 200S, Fortsetzung
Module Module Address space of the
Without
grouping
1 bytes
4 bytes
8 bytes
Feedback interface (PII)
software
EBx
EBx
:
EBx+7
EBx
:
EBx+7
EBx+8
inputs
With Without
1)
grouping grouping
------ ------
4 bytes
8 bytes
------
Status Byte
ABx
Option
:
handling
ABx+7
ABx
Option
:
handling
ABx+7
Status Byte
ABx+8
ET 200S Distributed I/O System
Address space of the
outputs
With
1)
grouping
Control interface
(PIQ)
------
------
Option
handling
Option
handling
Not applicable
EWA-4NEB 780602402-12