Siemens SIMATIC ET 200S Manual page 563

Option handling in PIQ/PII
PIQ: AB x to AB x+7
Slots 2 to 63
PII: : EB x to EB x+7
Slots 1 to 63
Status byte power modules
IB x+8
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Address Space of the Input and Outputs of the ET 200S
QB/IB x
QB/IB x+1
15
QB/IB x+2
23 22 21
QB/IB x+3
31
QB/IB x+4
39
QB/IB x+5
47
QB/IB x+6
55
QB/IB x+7
63
0: Parameter assignment for option handling applies.
RESERVE modules are permitted:
•
•
•
1: Parameter assignment for option handling is
cancelled. RESERVE modules are not accepted on
this slot:
•
•
•
The RESERVE module or an incorrect module is on
0:
the slot or a module has been removed.
The configured module is on the slot.
1:
7 6 5 4 3 1
2
0 0 0
1: Sensor or load voltage is missing
(present in all PM-E power modules)
1: defective fuse (only in the case of the PM-E 24--48
VDC/120--230 VAC)
Diagnostic bits of the
power modules
7 6 5 4 3 1 0
2
4 2
6 5 3 1 *
7
14 13 12 11 10 9 8
20 19 17 16
18
30 29 27 26 25 24
28
36
38 37 35 33 32
34
46 45 44 43 42 41 40
54 53 52 51 50 49 48
61 60
62 59 58 57 56
The station is engaged in data transfer.
A diagnosis is not reported.
The SF LED on the interface module is off.
The station is engaged in data transfer.
The diagnosis "Incorrect module" is reported.
The SF LED lights up on the interface module
0 Bit no.
0: load voltage present
1: no load voltage
Bit no.
* Not applicable
C-3