Commissioning and Diagnostics
Station status 2
Table 6-9
Bit
0
1: New parameters have to be assigned to the DP slave.
1
1: A diagnostic message has been issued. The DP slave will not work until
2
1: The bit is always set to "1" in the DP slave.
3
1: Response monitoring has been enabled for this DP slave.
4
1: The DP slave has received the "FREEZE" control command
5
1: The DP slave has received the "SYNC" control command
6
0: The bit is always at 0.
7
1: The DP slave has been disabled, that is, it has been removed from the
1
The bit is updated only if another diagnostic message changes, too.
Station status 3
Table 6-10 Structure of station status 3 (byte 2)
Bit
0 to 6
7
6-32
Structure of station status 2 (byte 1)
the fault has been corrected (static diagnostic message).
processing in progress.
0: The bits are always at 0.
1:
There are more diagnostic messages than the DP slave can
•
store.
The DP master cannot enter all the diagnostic messages sent by
•
the DP slave in its diagnostic buffer (channel-specific diagnosis).
Meaning
Meaning
ET 200S Distributed I/O System
1
.
1
.
EWA-4NEB 780602402-12