Siemens SIMATIC ET 200S Manual page 247

Parameters for the IM151-1 HIGH FEATURE interface module
Table 8-3
IM151-1 HIGH FEATURE
DP interrupt mode
Operation at Preset -- <>
Actual configuration
Diagnostics interrupt
Hardware interrupt
Insert/Remove module
1) 2)
interrupt
Module diagnosis
Module status
Channel-specific diagnostics
Analog-value format
Interference Frequency
Suppression
Reference junction slot
Reference junction input
1)
In the device database file, the default setting of the parameter is "Disable".
2)
Only configurable in DPV1 mode.
3)
The default settings are applicable for the default startup (if no other parameters are
specified by the DP master).
Table 8-4
IM151-1 HIGH
FEATURE
Synchronize DP slave
with DP cycle
Time Ti (read in
process values)
Time To (output
process values)
1)
Only parameterizable as of STEP 7 V5.1 with ServicePack 3
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Parameters for the IM151-1 HIGH FEATURE interface module
(parameter assignment tab)
Value range
DPV0/DPV1
Disable/enable
2)
Disable/enable
2)
Disable/enable
Disable/enable
Disable/enable
Disable/enable
Disable/enable
SIMATIC S7/
SIMATIC S5
50 Hz/60 Hz
None/2 to 63
RTD on channel 0/
RTD on channel 1
Parameters for the IM151-1 HIGH FEATURE interface module (clocking tab)
Value range
Disable/enable
1)
(Values are preset by
1)
STEP 7)
(Values are preset by
1)
STEP 7)
Interface Modules
3)
Default
DPV1
enabled
enabled
enabled
enabled
enabled
enabled
enabled
S7
50 Hz
none
0
Default setting
disable ET 200S
(Value is preset by ET 200S
STEP 7)
(Value is preset by ET 200S
STEP 7)
Effective range
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
Effective range
8-3