Siemens SIMATIC ET 200S Manual page 249

Option handling, general
Using this parameter you can enable or disable the option handling parameter for
the entire ET 200S.
Option handling: Slots 2 to 63
Using this parameter you can enable or disable the checking of the configuration.
• Slot 2 to 63 is enabled. A RESERVE module can also be inserted into the slot
instead of the configured electronic module without triggering a diagnosis.
• Slot 2 to 63 is disabled: Only the configured module may be inserted in the slot.
RESERVE modules are treated as incorrect modules. Depending on the setting
of the "Operation at Preset <> Actual Configuration" parameter, the ET 200S
will either fail or remain in data transfer.
Diagnostic interrupt
This parameter allows you to enable or disable diagnostic interrupts.
Diagnostic interrupts are supported
• on the PROFIBUS DP, if the ET 200S is in DPV1 mode.
• on the PROFINET IO.
Hardware interrupt
This parameter allows you to enable or disable hardware interrupts.
Hardware interrupts are supported
• on the PROFIBUS DP, if the ET 200S is in DPV1 mode.
• on the PROFINET IO.
Insert/remove module interrupts
This parameter allows you to enable or disable insert/remove module interrupts.
Insert/remove module interrupts are supported
• on the PROFIBUS DP, if the ET 200S is in DPV1 mode.
• on the PROFINET IO.
Analog-value format
Here you set the number format for all analog electronic modules.
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Interface Modules
8-5