Brief Instructions On Commissioning Et 200S; Commissioning On Profibus Dp; Introduction - Siemens SIMATIC ET 200S Operating Instructions Manual

Brief instructions on commissioning ET 200S

2.1

Commissioning on PROFIBUS DP

2.1.1

Introduction

Introduction
The following simple examples will teach you how to commission the ET 200S on the
PROFIBUS DP step by step:
● ET 200S installation and wiring up
● Configuring ET 200S in the SIMATIC manager
● Creating a user program
● Switching on ET 200S
● Evaluating diagnostic messages:
Requirements
● You have set up an S7 station consisting of a power supply component and a DP master
●
● The PD must be connected to the DP master.
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
– Removing and inserting of modules
– Switching off the load voltage on the power module
– Wire break in the actuator wiring on the digital output module
(e.g. CPU 315-2 DP). For this example a CPU 315-2 DP is used as the DP master. You
can of course use any other DP master (standard IEC 61784-1:2002 Ed1 CP 3/1).
STEP 7
(V5.0 with ServicePack 3 or higher) is installed on your programming device. You
know how to work with
STEP 7
.
2
21