Table of Contents
Advertisement
5.2
Commissioning and starting up the DP slave
Software requirements
Table 5-2
Software requirements for commissioning an ET 200X (except DESINA)
Project software
used
STEP 7
COM PROFIBUS
Configuration
software for a
different DP master
being used
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Version
v Version 3.1
The type file of the DP slave is integrated in
STEP 7.
u Version 3.1
Included in STEP 7 or new modules to be
embedded with OM or type file
w Version 2.1
You have embedded the type file of the DP slave in
COM PROFIBUS.
You require the device master file and the contents
of the configuration frame and parameter
assignment frame for the DP slave (refer to
Appendix B and the configuration and parameter
assignment frame for ET 200X at
http://www.ad.siemens.de/simatic-cs).
Commissioning and Diagnostics
Explanations
5-7
Advertisement
Table of Contents
