Inserting, Removing, And Swapping Pims In The Msam; Inserting A Pim - Viavi T-BERD MTS 5800 Getting Started Manual

Figure 27 DMC with CSAM inserted (left) and MSAM v2 inserted (right)
6 Using the screwdriver, tighten each screw. You can also use your fingers to
tighten the screws; however, using the screwdriver will ensure a more secure
connection.
The MSAM or CSAM is connected to the base unit or DMC chassis.

Inserting, removing, and swapping PIMs in the MSAM

Inserting a PIM

After connecting the MSAM to the base unit or DMC chassis, you can insert up to two
PIMs into the two ports provided on the MSAM. The PIM(s) will provide the physical
interfaces that you need to connect to the circuit for testing.
March 2018
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Chapter 2 Assembling Your Instrument

Inserting, removing, and swapping PIMs in the MSAM

Page 37