Chapter 1 Overview
About the DMC Assembly
For assembly instructions, see
on page
Restrictions
With the introduction of the MSAMv2, 6000Av2, and 8000v2, new applications are
enabled due to variations in the design. If you require voice support for DS VF and VoIP
you are encouraged to use a MSAMv2 with all versions of the 6000A and 8000 main-
frames.
About the DMC Assembly
The DMC chassis is used with the T-BERD ⁄ MTS 8000 base unit. It provides two
MSAM or CSAM slots, allowing you to insert two MSAMs and up to four PIMs, or two
CSAMs. This provides connections for testing up to four independent circuits simulta-
neously.
Figure 19 T-BERD ⁄ MTS 8000 base unit with a
Figure 19
"Connecting a DMC to a base unit" on page
Base unit requirements
if you intend to test using two MSAMs or CSAMs in a DMC chassis, verify that the
T-BERD ⁄ MTS 8000 base unit satisfies the requirements stated in
If your base unit does not satisfy the DMC requirements, contact Viavi Customer Care
for instructions on returning the base unit for a factory upgrade. For details, see
"Returning equipment to Viavi" on page
Page 24
"Inserting, removing, and swapping PIMs in the MSAM"
37.
shows a DMC connected to a base unit. For assembly instructions, see
T-BERD/MTS/SC Getting Started Guide
22046561, Rev. 016
DMC
MSAM or
CSAM slot
MSAM or
CSAM slot
28.
263.
Table 9 on page
28.
March 2018