Handling Sfp/Sfp+, Xfp, And Qsfp+ Transceivers; Inserting An Sfp/Sfp+, Xfp, Or Qsfp+ Transceiver - Viavi T-BERD MTS 5800 Getting Started Manual

Chapter 2 Assembling Your Instrument

Handling SFP/SFP+, XFP, and QSFP+ transceivers

Handling SFP/SFP+, XFP, and QSFP+ transceivers

If you have a 5800, CSAM, MSAM chassis, you can insert transceivers designed for
testing a variety of optical circuits. Examples of SFP and QSFP transceivers are
provided in
• The 5800v1 accept SFP transceivers.
• The 5800v2, 5882 and CSAM accept SFP/SFP+ transceivers.
• The 5800-100G accepts QSFP+/QSFP28 and SFP/SFP+/SFP28 transceivers.
• The MSAM (with connected SFP and/or XFP PIMs), accepts SFP and XFP trans-
ceivers.
• The CSAM accepts QSFP+ transceivers.
Each of these pluggable transceiver modules has similar insertion characteristics.
Figure 36
Figure 36 Copper SFP
Figure 37
40GE fiber circuits.
Figure 37 QSFP+ transceiver (40GE circuits)

Inserting an SFP/SFP+, XFP, or QSFP+ transceiver

Before inserting an SFP/SFP+, XFP, or QSFP+ transceiver, consider the following:
• Applied power must not exceed the power level specified on the panel for each
optical connector.
Page 48
Figure 36 and Figure
shows a Copper SFP (used to test copper over 10GigE LAN circuits).
shows the QSFP transceiver+ used to perform out of service testing over
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
37.
March 2018