Launching A Test Using The Test Menu - Viavi T-BERD MTS 5800 Getting Started Manual

Chapter 4 Basic Testing
Step 1: Selecting a test application
3 Do the following to customize the Quick Launch screen:
–
–
–
–
–
–
4 If you want the Main screen to appear by default when you start your test instru-
ment (instead of the Quick Launch screen), select Show results at startup.
The Quick Launch screen is customized.

Launching a test using the Test Menu

Tests are grouped and listed on the Test Menu by technology (for example, Ethernet or
SONET), signal, payload, and test mode.
NOTE:
If the Test Menu is not displayed, select the All Tests button (located at the bot-
tom left of the Quick Launch screen). The Test Menu will appear.
To select a test using the Test Menu
1 On the Main screen, click Select Test.
The Quick Launch screen appears.
–
–
2 Using the Test Menu, select the technology, signal, payload, and test mode for
your test.
The instrument displays a message asking you to wait while it loads the test.
3 Wait for the Main screen to appear, and then proceed to
test" on page
Page 112
To add a shortcut: Select the Add Shortcut button, then use the Test Menu
that appears to navigate to and select the test that you want to save as a
shortcut on the Quick Launch screen.
To add a saved test: Select the Add Saved Test button, then select a previ-
ously saved test from the Select Saved Test dialog box. Press Ok to save the
selected saved test - it will appear as a favorite on the Quick Launch screen.
To delete one or more tests: Use the Delete button to delete a single selected
test, or the Delete All button to delete all selected tests. You will be prompted
to confirm the deletion before the tests are deleted from the Quick Launch
screen.
To rename a test: Select the test that you want to rename, then select the
Rename button. Enter a new name for the test, then select Ok.
To rearrange the tests: Use the Move Up and Move Down buttons to move
the selected test to a new position within the list of tests.
To insert a separator between two tests: Select the test under which you want
to insert the separator, then select the Separator button. This allows you to
group tests on the screen by technology, line rate, technician, customer, or
any manner that is helpful to you.
If the Test Menu appears to the left of the screen, proceed to
If the Test Menu does not appear, select the All Tests button (located at the
bottom left of the Quick Launch screen). The Test Menu will appear.
113.
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
step 2.
"Step 2: Configuring a
March 2018