Viavi T-BERD MTS 5800 Getting Started Manual page 36

Chapter 1 Overview
About the T-BERD / MTS 5800 and SC 4800
Figure 4
10/100/1000M connector
A 10/100/1000M connector allows you to connect the SC 4800 to an electrical Ethernet
circuit to transmit and analyze traffic.
SFP+ connector
The SFP+ connector allows you to connect the SC 4800 to 1 Gigabit Ethernet, 100 FX,
or 100M Ethernet circuit to transmit and then analyze traffic.
DS1/E1 connector (on SC 4800P only)
One balanced 120 Ohm RJ 48 transmitter/receiver allows you to connect the 4800 to
an E1 (2M) circuit to transmit and analyze traffic.
Page 12
SC 4800P connector panel
NOTE:
The E1 and DS1 interfaces should not be connected at the same time. After
running your test, disconnect from one interface before connecting to the
other interface.
T-BERD/MTS/SC Getting Started Guide
22046561, Rev. 016 March 2018