Creating A Report - Viavi T-BERD MTS 5800 Getting Started Manual

2 To specify information about the device you are currently testing, select the
Device Under Test tab (if it isn't already displayed), and then use the keypads
provided to type the following:
–
–
–
–
–
3 If you want to specify additional comments concerning test results or the tester,
select the Tester Comments tab, and use the keypads provided to type additional
information.
4 If you want to change the default name for your Dual Module Carrier,
Transport Module, and MSAM as provided in the report, select the Test Instru-
ment tab, and then type the revised model name.
5 Select Ok to store the report details and return to the Main Screen.
Report details are specified.

Creating a report

You can create reports in a PDF, CSV, Text, HTML, or XML format. Before creating a
report, you can choose the type of content provided in the report. For example, you can
include the details you specified as the User Info, select specific configuration groups
(corresponding to the information that you specified on the setup tabs), and select key
result groups that you want to review in detail.
You can also indicate whether you want to include captured screen shots in the report.
To create a report
1 On the Main screen, select Reports > Create Report ...
The Create Report dialog box appears.
2 Your unit will automatically assign a default file name to your report as follows:
–
–
–
–
–
March 2018
Owner (represents the owner of the device).
Device Under Test (represents the name or model of the device).
Software Revision (represents the software revision the device is currently
running).
Serial Number.
Comment.
The port number (if applicable) appears at the beginning of the name. For
example, if you are creating a report while running a test on Port 1, "P1_"
appears at the beginning of the name.
The interface appears next. For example, if you are currently running a test
on a 1 Gigabit Ethernet circuit, "1GigE" appears after "P1_.
The date and time, expressed per ISO 8601, appear after the interface.
Finally, a "report" suffix ends the filename.
The appropriate extension for the file format that you specify will be assigned
when the report is created. For example, if you select the Text format, a "txt"
extension will automatically be assigned to the file name.
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Chapter 4 Basic Testing
Creating and printing reports
Page 133