Chapter 3 Starting up
Fitting and removing a module
Fitting and removing a module
The 4000 V2 Platform must be switched off, and if it is operating on the
mains, its supply cable must be unplugged.
Fitting a module
•
Turn the instrument face down on the work surface.
•
Set the two notches on the module part (1a) into the two holes provided for that
purpose on the Base (1b).
•
Make flush the 2 connections (2a & 2b), on module and base.
•
Once positioned, fix the module to the base screwing the 2 screws fixing the
receptacle.
•
Repeat the same process for the other module if 2 small modules are to be used.
Fig. 6
Fixing the module to the base
1b
2b
14
Captive screws fixing the module(s)
User Manual
74000NG012 Rev. 003
1a
2a