Appendix A Specifications
Jitter and Wander specifications
Measurement filters
Measurement filters are defined per ITU-T Recommendation O.172 (04/2005).
Memory requirements
Table 151
when measuring wander.
Table 151 Memory requirements for wander measurements
Sample rate
1/second
30/second
60/second
1000/second
1. Supported on MSAM only.
The maximum wander measurement time is only limited by the available hard disk
space. However, you can only perform wander analysis (MTIE/TDEV) for the first 8.64
million samples of the measurement.
Interface specifications (Jitter and Wander applications)
Table 152
wander applications. The interfaces meet the specifications stated in ITU-T Recom-
mendation G.957/GR-253.
Table 152 Optical interface specifications (Jitter and Wander applications)
Item
Optical connector types
Wavelength
Line rates
Line code
Transmitter specifications
Transmit level
Fiber mode compatibility
Frequency offset
Frequency accuracy
Page 230
describes the memory requirements (storage requirements) for the base unit
Required flash/hard disk space
approximately 150 KB/hour
approximately 5 MB/hour
approximately 9.0 MB/hour
1
approximately 150 MB/hour
describes the specifications for the optical connectors when running jitter and
1
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Description
FC, SC, ST, or LC
1310 and 1550 nm
– 155 Mbps
– 622 Mbps
– 2488 Mbps
– 2666 Mbps
Scrambled NRZ
-2 to +3 dBm
1310 and 1550 nm — singlemode fiber
+50 ppm from the nominal rate,
in 1 ppm steps
+1,5 ppm +1 ppm per year aging
March 2018