Fitting And Removing A Module Carrier Or A Module; Warning; Key Principles; Required Tools - Viavi 8000 V2 Platform User Manual

Chapter 3 Starting up

Fitting and removing a module carrier or a module

Fitting and removing a module carrier or a module

Warning

Key principles

Required tools Large, flat blade screwdriver
12
The 8000 V2 Platform must be switched off, and if it is operating
on the mains, its supply cable must be unplugged.
When connecting or disconnecting modules, focus on the following prin-
ciples to ensure a secure connection and avoid damaging the connec-
tors:
Alignment. Ensure that the holes on the corners of the Module or Battery
Module are aligned with the holes on the component you are attaching it
to. For example, if you are attaching the Optical Module to the base unit,
ensure that the holes of the module are aligned with the holes on the
base unit.
Parallel position. Ensure that you are holding the Module or Battery
Module in a position parallel to the base unit or Module (as illustrated in
Figure 9 on page 15). If either module is held at even a slight angle, there
is a risk of damage to the connectors.
Proper torque. Ensure that you tighten the screw using the hex key (for
the Module) or a flat blade screwdriver (for the Battery Module) until you
feel a slight resistance, and then tighten it using an additional 1/4 turn. If
you are using a torque wrench, apply 1.5 N-m (13.3 in-lb) to the final turn.
You will need a large, flat blade screwdriver to remove and then replace
the battery module on the base unit.
Hex key (provided)
A 5 mm hex key is provided in a groove on the inside panel of the battery
module. This key is used to secure and then tighten the screws that
connect the module to the base unit.
User Manual 78100000202 Rev. 003