Chapter 3 Getting Started
Safety instructions
Safety instructions
Removing and attaching a SIM
24
The HST-3000 should only be used for the purpose and under
the conditions for which it is intended. Operation outside these
conditions may be dangerous or may damage the instrument.
For additional safety information, refer to the printed safety
document or the electronic safety document located on the
HST user documentation CD-ROM.
When shipped from the factory, the service interface module
(SIM) comes attached to the unit. If another module is ordered
later, or if you have more than one module, this section
describes how to replace the module.
NOTE:
Before removing or attaching a module, the unit must be
powered down and all cables must be disconnected.
CAUTION: STATIC SENSITIVE
Static shock may damage the instrument. Observe anti-
static precautions when handling the module.
HST-3000 Base Unit User's Guide