Usb Connector; Sma Connector; Msam Pims - Viavi T-BERD MTS 5800 Getting Started Manual

Chapter 1 Overview
About the MSAM Assembly

USB connector

The MSAMv2 USB connector provides analog audio using a Viavi analog headset and
USB-to-analog adapter. When using the MSAMv2, the audio from the MSAMv2 is used
(USB audio from the base unit is disabled). USB 2.0 is not supported. For best audio
quality, the switch on the headset should be set to the lowest position (the smallest of
the three dots, closest to the wire).

SMA connector

The MSAMv2 SMA connector provides access to external reference timing
For assembly instructions, see
or DMC" on page

MSAM PIMS

Table 7
Table 8
Catalog Number
CPHSDATA
CPCDI
CPDS1BANT
CPE1BNC
CPE1RJ48
CPE3DS3BNC
Page 20
CAUTION: DAMAGE TO COMPONENTS
Use caution when connecting the cable to the SMA connector. Over-tight-
ening could damage internal components. Finger tighten only.
35.
lists the PIMs available for testing from various interfaces using the MSAM.
MSAM PIMs
Description
Data communications PIM with universal data
communications connector.
Diphase PIM with dual BNC connectors
DS1 jitter capable PIM with Bantam connector
A DS1 PIM is shown in
E1 jitter capable PIM with BNC connector
An E1 PIM with a BNC connector is shown in
Figure 16 on page
E1 jitter capable PIM with RJ-48 connector
E3/DS3/STS-1 jitter capable PIM
An E3/DS3/STS-1 PIM is shown in
on page
T-BERD/MTS/SC Getting Started Guide
22046561, Rev. 016
"Inserting MSAMs or CSAMs into the 6000A base unit
Figure 15 on page
23.
23.
Compatible
Chassis
C0404
C1004
C0404-v2
C1010-v2
C0404
C1004
C0404-v2
C1010-v2
All
22.
All
All
All
Figure 17
March 2018