Viavi T-BERD MTS 5800 Getting Started Manual page 5

Product Regulatory Compliance
Federal Communications Commission (FCC) Notice
This product was tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commer-
cial environment. This product generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this product in a residential
area is likely to cause harmful interference, in which case you will be required to correct
the interference at your own expense.
The authority to operate this product is conditioned by the requirements that no modifi-
cations be made to the equipment unless the changes or modifications are expressly
approved by Viavi.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–
–
–
–
In order to maintain compliance with the limits of a Class A digital device Viavi requires
that quality interface cables be used when connecting to this equipment. Any changes
or modifications not expressly approved by Viavi could void the user's authority to
operate the equipment.
Industry Canada Requirements
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appar-
eils radio exempts de licence. L'exploitation est autorisée aux deux conditions suiva-
ntes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This Class A digital apparatus complies with Canadian ICES-003.
March 2018
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
T-BERD/MTS/SC Getting Started Guide
22046561, Rev. 016 Page iii