Required Tools - Viavi T-BERD MTS 5800 Getting Started Manual

Table 9
Requirement
Touch screen
Hard drive
BERT Software Version 5 or above
BERT Software Version 7.0 or above
BERT Software Version 8.0 or above
BERT Software Version 14.0 or above
400MHz CPU
1000MHz CPU
256 MB DRAM
2GB DRAM
1. Software version 8.0 can also be run on the MSAM assemblies.
To verify the requirements on a base unit
1 Press the SYSTEM/HOME key.
2 To verify the current BERT software version, select the Help Page soft key.
Under Software Version Information, observe the BERT software version.
–
–
–
3 To verify the CPU speed and DRAM, select the Services Data soft key.
Under Services Data, check the CPU speed and the Memory.
If your base unit does not meet the requirements stated above, contact Viavi Customer
Care for assistance.

Required tools

• Large, flat blade screwdriver. You will need a large, flat blade screwdriver to
remove and then replace the battery module on the base unit.
• Hex key. A hex key is provided in a groove on the inside panel of the battery
module. This key is used to secure and then tighten the screws that connect the
DMC to the base unit.
March 2018
T-BERD ⁄ MTS 8000 base unit requirements
NOTE:
Depending on the version of T-BERD ⁄ MTS 8000 base unit you have, the
key may be labeled SYSTEM or may be labeled HOME (on UIMv2).
If the software version is lower than Version 5.0, you must upgrade the soft-
ware on your base unit before connecting a Version 2 Transport Module.
If the software version is lower than Version 7.0, you must upgrade the soft-
ware on your base unit before connecting a Version 3 Transport Module.
If the software version is lower than Version 8.0, you must upgrade the soft-
ware on your base unit before connecting a DMC.
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Chapter 2 Assembling Your Instrument
Connecting a DMC to a base unit
DMC
X
X
1
X
X
X
Page 29