E1 (Bnc) Pim Specifications; Receiver (Bnc) - Viavi T-BERD MTS 5800 Getting Started Manual

1. The designation dBdsx is a level measurement in dB relative to dsx level, which is 6 V peak-peak. A signal with a
peak-peak level of 6V corresponds to 0 dBdsx.
2. Available only when unframed all ones (AIS) signal is detected.

E1 (BNC) PIM specifications

Table 90 on page 201
PIM.

Receiver (BNC)

The E1 receiver operates as per ITU-G.703 (11/01).
cations.
Table 90 E1 BNC receiver specifications
Parameter
Connector
Bit rate
Frequency measure-
ment
Level Measurement
(Unbalanced)
1. The designation in dBnom is relative to nominal signal 2.37 Vp.
Table 91
Table 91 E1 receiver sensitivity specifications
Termination Type
Bridge (HI-Z)
Terminate
PMP
March 2018
through Table 93 on page 202
Specification
One unbalanced RX1 BNC, and one unbalanced TX/RX2
BNC; both BNCs can be used as receivers
2.048 Mbps
Range: 2.048 MHz ±250 ppm
Accuracy: ±1.5 ppm, ±1 ppm per year aging
Resolution: 1 Hz
Level Vp
Range: +4.0 V to 0.03 V
Accuracy: ±0.02 V ± 10%
Resolution: 0.01 V
Level dBnom
Range: 4.5 dBnom to -37 dBnom
Resolution: 0.1 dB
lists the input sensitivity specifications for the E1 receiver.
Impedance
>750
Ω
75 unbalanced
Ω
75 unbalanced
Ω
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
list specifications for the E1 (BNC)
Table 90 lists the receiver specifi-
1
:
Input Range
+4 to -35 dBnom due to cable loss
+4 to -35 dBnom due to cable loss
-20 dBnom due to resistive loss in
addition to 0 to -6 dB due to cable loss
Appendix A Specifications
MSAM specifications
Page 201