Appendix A Specifications
Jitter and Wander specifications
Table 139 Optical interface specifications (Non-Jitter/Wander) (Continued)
Item
Receiver shutdown
2.5 Gbps option
10 Gbps long reach
Reflectance
Level measurement range
2.5 Gbps
622 Mbps
155 Mbps
Level measurement range for
10 Gbps
1310 nm and 1550 nm
IR RX
LR RX
850 nm
Level measurement accuracy
Level measurement resolution
APS
resolution
accuracy
RTD
resolution
accuracy
1. Remove the connector to clean the optical fiber.
2. Do not apply a greater than –8 dBm optical-level signal to the long reach receiver on the Dual Module Carrier, and
MSAM. Damage to the receiver may occur.
Jitter and Wander specifications
Refer to the following sections for jitter and wander specifications for the T-BERD / MTS
5800 and MSAM:
•
"Electrical jitter and wander specifications" on page 224
•
"Interface specifications (Jitter and Wander applications)" on page 230
•
"Optical jitter and wander specifications" on page 231
Electrical jitter and wander specifications
This section provides electrical jitter and wander specifications for the T-BERD / MTS
5800 and MSAM. For specifications, see:
•
"Standards" on page 225
Page 224
Description
2
-5.9 dBm
-5.9 dBm
Per Telcordia
- 6 to -30 dBm
-5 to -31 dBm
-5 to -31 dBm
+0 to -17 dBm
-6 to -20 dBm
+0 to -14 dbm
±3 dB
0.1dB
1ms
1ms
1 μs
2 μs
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
GR-253-CORE Issue 4-2005
March 2018