Setting Up The Display; Adjusting Screen Brightness; Setting Up The Screen Saver - Viavi T-BERD MTS 5800 Getting Started Manual

The Battery Status page indicates the charge level (both in percentage under the
battery and the color of the battery), whether the adapter is plugged in, and indi-
cates the battery temperature range.

Setting up the display

Setting up the display includes setting the screen brightness and setting up the screen
saver.
NOTE:
The Display menu also allows calibration of the touchscreen. See
the T-BERD / MTS 5800 and SC 4800 touchscreen" on page

Adjusting screen brightness

The following procedure describes how to adjust the screen brightness.
To adjust the screen brightness
1 Select the System icon, then select Display.
2 Change the brightness level by moving the slider left or right.

Setting up the screen saver

If you are operating the instrument using the battery, you should set up the screen saver
to switch off the screen automatically after the unit has not been used for a specific
interval of time. For instructions on setting up the screen saver on a MSAM, refer to the
8000 Base Unit User Manual or 6000A Base Unit User Manual. For the T-BERD / MTS
5800 and SC 4800, see below.
To set up the screen saver
1 Select the System icon, and then select Display.
2 To enable the screen saver, click the check box next to Enable automatic screen
saver.
3 To change the message displayed as a screen saver, click in the Message field,
and then enter the message.
4 To specify the time to wait until the screen saver begins, do the following:
a
b
March 2018
Click on the drop down next to the Delay field, and then specify the time unit,
for example, seconds, minutes or hours.
Click in the Delay field. A keyboard appears. Enter the amount of time, and
then click OK. For example, if you selected minutes in the previous step,
enter the number of minutes of delay.
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Chapter 3 Getting Started
Setting up the instrument
"Calibrating
247.
Page 73