Viavi T-BERD MTS 5800 Getting Started Manual page 183

2 Select the MicroScope icon.
The Fiber Microscope screen appears.
3 Connect the microscope to the optical patch cord or bulkhead.
NOTE:
Although some microscopes can inspect multi-fiber or ribbon fiber (depending
on the microscope and the tip used) the T-BERD ⁄ MTS 5800's microscope
application supports simplex fiber only.
The video of the fiber appears.
4 Specify which Tip is being used on the microscope.
5 Adjust the focus as needed using the wheel on the microscope. The color of the
vertical bar on the left indicates the quality of the focus: green is good, yellow is
ok, red is poor. Older microscopes have a blue bar only.
Optional. To verify which version you have, use the Viavi FiberChek Pro desktop
application.
6 Select the inspection Profile.
If you have a custom profile, do one of the following:
–
–
7 Select Other settings and then check the Auto-center check box. If checked, the
live picture automatically centers on the fiber center. If not checked, the picture
will center at the last location of a fiber center following an analysis. High magnifi-
cation is always automatically centered.
8 To manually inspect the fiber, do the following:
a
b
c
d
e
9 To test the fiber, do the following:
a
b
NOTE:
The test will fail if the focus quality is poor (vertical bar is red).
March 2018
Use the file manager to put the file into the disk/bert/scope/profiles/ folder,
and it will appear in the P5000i viewer the next time it is launched (if it is
already running, it will need to be closed and reopened).
Click the Import from USB button next to the profile list to import your
custom profile. Once imported it may be selected in the viewer.
Observe the video of the fiber, and if desired, magnify the image by selecting
the Zoom In button.
Select Other settings and then specify Freezes as the Test Button setting.
This captures a snapshot.
Select the Test button.
To compare the current capture to the live feed, select Overlay
To return to the live video, select the Live button.
Select Other settings and then specify Tests as the Test Button setting.
Select the Test button.
T-BERD/MTS/SC Getting Started Guide
22046537, Rev. 016
Chapter 7 Optical Tools
Inspecting fiber
Page 159