Ekip Touch Overview; General Characteristics - ABB SACE Tmax XT2 User Manual

Ekip Touch Overview

3 - General characteristics

Families SACE Tmax XT2 - XT4 can be configured with two trip unit families:
Both families perform protection and measurement functions referring to system notifications and
are available in different models and versions.
Ekip Touch in particular is available in four versions:
As already mentioned, the description of Ekip Touch is included in this manual. For the
description of Ekip Dip refer to the Installation Instructions, see page 4 for references.
Main functions The Ekip Touch Trip unit guarantees the following functions:
The Ekip Touch functions are guaranteed both by transducers and actuators in the circuit breaker
and by a wide range of external accessories.
Presentation
Figure 2
Ekip Touch has an LCD display (, page 21) to access the configuration menus and to check
parameters, measurements, and information.
The connections to external electronic accessories are available on the side terminal board (),
the connections to the internal accessories on the internal terminal board (), see page 11 for
an overview of the electronic accessories (see the Technical Catalog and Wiring Diagrams for
all the other accessories).
1SDH002031A1002 ECN000092998

Ekip Dip with dip-switch interface

Ekip Touch with LCD display

Ekip Touch

Ekip Touch Measuring

Ekip Hi-Touch

Ekip M Touch
1. Measurement: measurement of different quantities including: currents, voltages, powers,
energies.
2. Protection: based on the measurements detected and the parameters configured by the
user, the Trip unit checks for an alarm and, if necessary, commands the tripping of the
circuit breaker.
3. Signaling: management of contacts and communication networks to optimize system
efficiency, communication between different CBs, and other functionalities
1
2
Rev. B
3
SACE Tmax XT2 – XT4 | 6