ABB SACE Tmax XT2 User Manual page 166

Output Ekip Touch can be configured in such a manner that the contacts of each output are closed or
open according to one or more events, with different programming options (see Menu on page
166)).
The output of each module consists of 2 contacts (K11-K12 and K13-K14 for model 2K-1; K21-
K22 and K23-K24 for model 2K-2; K31-K32 and K33-K34 for model 2K-3), insulated from unit
and from the other outputs, which have the following electrical characteristics:
Characteristics
Maximum switchable voltage
Switching power
Dielectric strength between open contacts
Dielectric strength between each contact and coil
The module has three signalling LEDs:
Interface
Figure 43
LED
Power
I 11, I 12
O 11, O 12
If the Ekip Signalling 2K module is detected correctly by Ekip Touch the specific configuration
Menu
area in the Modules Settings menu is activated.
For each Ekip Signalling 2K module detected by Ekip Touch, a specific menu is available
containing the submenus of all the available and configurable inputs and outputs.
1SDH002031A1002 ECN000092998
NOTE: data on a resistive load
Description
Reports ON status and correct communication with Ekip Touch:

off: module off

fixed or flashing light synchronized on power LED of Ekip Touch: module
ON and communication with Trip unit present

flashing not synchronized with power LED of Ekip Touch (two fast flashes
per second): module ON and communication with Trip unit absent
Indicate status of the contacts of each output:

off: open contact

on: closed contact
Indicate status of the contacts of each input:

off: circuit open

on: short circuit
Rev. B
(NOTE)
Maximum limit
150 VDC / 250 VAC.
2 A @ 30 VDC, 0.8 A @ 50 VDC, 0.2 A
@ 150 VDC, 4A @ 250 VAC
1000 VAC (1 minute @ 50 Hz)
1000 VAC (1 minute @ 50 Hz)
SACE Tmax XT2 – XT4 | 166