ABB SACE Tmax XT2 User Manual page 98

Openings [2] Access to most recent trip
The information relating to the most recent trip, as well as in the Logs menu, can be accessed in
three different ways, depending on the Ekip Touch conditions:
Condition
Trip just occurred with
Ekip Touch - access
Trip just happened with
Ekip Touch - turned off
Quick consultation in all
other conditions
Min-Max In the Measurements - Logs - Measurements menu the Ekip Touch records the maximum and
minimum phase currents
measurements
The recording interval between one measurement and the next can be set with the parameter
Measurement interval - Measurement interval, available in the Settings menu (page 29).
The Enter, ESC, Right/Up and Left/Down buttons can be used to scroll through all recorded
measurements.
Each record is accompanied by the following information:


Reset measurements
The Measurement Reset command to clear all records is found in the Measurements - Logs -
Measurements menu
1SDH002031A1002 ECN000092998
Phase and value of the measurement
Date and time of the record
NOTES:

If the value is lower than the minimum viewable threshold, the record will show "..."
instead of the value

When the "Measurement interval" parameter is changed, the trip unit immediately
saves a record
Rev. B
Access
The main page is temporarily replaced by the trip information
page. Press the iTEST button to reset and return to the normal
page
Pressing the iTEST button shows the trip information page for a
few seconds
From any page other than a menu or a page opened from a
menu, press the iTEST button four times
SACE Tmax XT2 – XT4 | 98