ABB SACE Tmax XT2 User Manual page 202

Remote From the service connector (via Ekip Connect) or with system bus communication it is also
configurations possible to access additional parameters.
Parameter
CRL Enable
Clock update
hardening enable
SNTP Server
Location
SNTP Time zone
SNTP Daylight
Saving Time
Disable Gratuitous
ARP
Remote From the service connector (via Ekip Connect) or with system bus communication it is also
information possible to access additional information.
Information
HW and Boot version
Flash CRC status and result
Publish enable configuration
Configuration file
Security file
Certify Revocation List
Executable file
Configuration error
Sample time
Log time
Upload time
Configured device
Polling period API events
Connection client 1, 2, 3
Statistics
Status plant side
Status Cloud side
Application status
Status
1SDH002031A1002 ECN000092998
Description
Use the CRL (Certificate Revocation List) to verify the validity of the
server certificate
Enables monitoring of the time transmitted by SNTP servers
Sets the location of the SNTP server relative to the network where
the module is installed
Defines the time zone to be used for synchronization
Specifies whether the local country uses daylight saving time (ON)
or not (OFF)
Enable (ARP Enabled) the periodic generation of a Gratuitous ARP
message, used by Ekip Connect to quickly find the modules with an
Ethernet scan without knowing the IP address in advance
Description
General module information
Information on the correctness of the SW on the module
Enable content in the Security File
Name of the file with the information to be transmitted
(measurements, etc.)
Name of the file with the information requested by the module to
perform the transmission (addresses, certificates, etc.)
Name of the file containing the list of revoked certificates
Name of the firmware update executable file
Error status of the module configuration
Period of time for sampling data from connected devices
Period during which the acquired data are saved in the log
Period (calculated by the module) between each data transmission
Number of modules involved in the network with the Hub module
Period for which the module communicates with the API device
Addresses of the Modbus TCP clients connected to the module
Log of the last save operations and percentage of resources in use
Information related to the quality of communication with other devices
Status of errors related to the TLS session established between the
module and the server
Progress indicators for operations
General module indicators: status of SNTP, flash, cable connection,
FW availability, file errors, etc
Rev. B
Default
+00:00
OFF
ARP
enabled
SACE Tmax XT2 – XT4 | 202