ABB SACE Tmax XT2 User Manual page 154

Remote From the service connector (via Ekip Connect) or with communication by system bus it is possible
configurations to access additional parameters:
Parameter
Preferred
configuration file
Enable IEEE
1558
IEEE 1588
Master
IEEE 1588 Delay
mechanism
Time zone
Daylight Saving
Time
TFTP Security
level
CB Open/CB
Close command
Falg word hex
1SDH002031A1002 ECN000092998
Description
If several configuration files are present, it enables the file
hierarchy to be defined between .cid and .iid
Permits the IEEE 1588 protocol for distributing the clock and
synchronization signal to be enabled
Enables the module to be set as a master in the network
segment to which it belongs (synchronization clock)
Enables the data exchange mode between module and
master, between Peer-to-Peer and End-to-End to be
chosen
Defines the time zone to be used for synchronism
Enables it to be selected whether there is daylight saving
time(ON) or not (OFF) in the country to which the
synchronization time refers.
Defines the file loading procedure:

TFTP always On= port open, loading still possible

TFTP enable required= port normally closed; to start
loading, the Enable TFTP command must be run at the
start of the procedure and the disable TFTP command
must be run at the end of the procedure (disable not
necessary, security command)
Defines the constraints for running remote open and close
commands:

standard commands = standard commands (without
constraints) active

CB operate request= standard commands not active;
use the programmable functions YC COMMAND and
YO COMMAND and the commands Request open
switch (28) and Request close switch (29)
set a filter on the selectivity status
NOTE: Enable IEEE 1558 and Enable SNTP client must not be enabled simultaneously
Rev. B
(1)
SACE Tmax XT2 – XT4 | 154
Default
.cid
OFF
OFF
End-to-
End
+00:00
OFF
TFTP
always
On
Standard
command
s
0