ABB SACE Tmax XT2 User Manual page 162

Interface The module has three signalling LEDs:
Figure 42
LED
Power
Link

Activity

Configurations Activating the local bus is required to start communication between the module and Ekip Touch
on menu and is available in the Settings menu (page 114).
If the module is detected correctly by Ekip Touch, in the Settings Modules menu, the following
communication parameters can be configured:
Parameter
Enable
Static IP address
ON
Static IP address
Static Network Mask
Static Gateway
address
SNTP client enabled
SNTP address
Server
Password
Remote firmware
update
1SDH002031A1002 ECN000092998
2
Description
Reports ON status and correct communication with Ekip Touch:

off: module off

fixed or flashing light synchronized on power LED of Ekip Touch: module ON
and communication with Trip unit present

flashing not synchronized with the power LED of Ekip Touch (2 rapid flashes
a second): module ON and communication with Trip unit absent
Indicates status of the communication:

off: incorrect connection, signal absent

fixed light: correct connection
Indicates status of the communication:

off: activity on line absent

flashing: activity on line present (receiving and/or transmitting)
Description
Switches on/switches off the communication between
module and server
Defines whether the module has the dynamic IP
address (Off) or static IP address (On)
If = On all associated parameters are enabled
Enables the static IP to be selected
Enables the subnet mask to be selected
Enables, in the presence of several subnets, the
IP address of the node to be selected to which the
module is connected
Permits enabling of SNTP distribution protocol of the
clock and synchronization signal
Enables the network server to be set that supplies
SNTP
Code required to record the module on Cloud
Enables the module's firmware to be updated. Two
parameters are available:

Enable, to configure the firmware download

Automatic, to automate updating the module
Rev. B
1
Default
Off
0.0.0.0
0.0.0.0
0.0.0.0
OFF
0.0.0.0
---
OFF
Automatic
SACE Tmax XT2 – XT4 | 162