Buttons
Button
iTEST
ESC
Enter
Right/
Up
Left/
Down
Service
The service connector allows connecting Ekip Touch to Ekip TT, Ekip T&P and Ekip
connector
Programming, with the possibility of temporarily powering the unit, configuration of the
parameters before startup, testing, extension of the configuration functions.
1SDH002031A1002
ECN000092998
Description
Allows quick viewing of some of the unit's information pages.
By pressing the button in succession the following pages are displayed:
Alarm list: if there are any alarms
Protection unit: with information on the Trip unit
Circuit breaker: with information on the CB
Last trip: with information on the last trip of the Trip unit, if available
Quick viewing via the iTEST button is active starting from the measurement pages
NOTE: with the Trip unit off and internal battery charged, pressing
iTEST temporarily turns on the Power LED and, only in case of TRIP,
the display with the protection information that caused the trip.
Press to:
Display the main menu when the Trip unit shows the measurement pages
Display the measurement pages when the Trip unit shows the main menu
Return to the upper level when navigating through the submenus
Press to:
Display the main menu when the Trip unit shows the measurement pages
Select the desired submenu
Confirm the entry of the password, required to update the Trip unit's
parameters
Confirm or cancel the changes to the Trip unit's parameters
Press to:
Scroll through the various measurement pages
Move to the right while navigating the main menu
Move up during submenu navigation
Change the single digits of the password, increasing them by one each time
the button is pressed
Press to:
Scroll through the various measurement pages
Move to the left while navigating the main menu
Move down during submenu navigation
Change the single digits of the password, decreasing them by one each time
the button is pressed
IMPORTANT: use only cables supplied by ABB or with ABB accessories
Rev. B
SACE Tmax XT2 – XT4 | 23