Ekip Cartridge - ABB SACE Tmax XT2 User Manual

38 - Ekip Cartridge

Ekip Cartridge is an external accessory that can be installed on a standard 35 mm DIN rail (DIN
EN 50022 type TS 35x15 mm), which allows other external accessories to connect to Ekip Touch:


Models Two different models are available that allow two or four modules to be connected respectively.
Connections Ekip Cartridge has two terminal blocks:
Figure 30
Connector
Access to all external connections are available on the respective modules, on the top side of
Ekip Cartridge.
Assembly To connect the module to Ekip Touch see the instruction sheets 1SDH002009A1503.
1SDH002031A1002 ECN000092998
All cartridge modules (e.g. Ekip Supply, Ekip Com, etc)
engaged/disengaged signal contact, in case of a CB in a detachable configuration
IMPORTANT: one module must always be Ekip Supply
2
Description
Terminal for connecting the engaged/disengaged status contact
NOTE: by default Ekip Cartridge is supplied with a jumper on the terminal
block
1
To use the engaged/disengaged status signal, remove the jumper from the
connector and connect the cables coming from the fixed part of the CB
Terminal for the connection of Ekip Cartridge to Ekip Touch:
Pin Description
K2 Power output for Ekip Touch (+24V DC)
2
K1 Power output for Ekip Touch (-24V DC)
W3 CAN bus
W4 CAN bus
Rev. B
1
SACE Tmax XT2 – XT4 | 129