Ekip Ci - ABB SACE Tmax XT2 User Manual

52 - Ekip CI

Ekip CI is an accessory module that can be configured with Ekip M Touch that allows the
management of a contactor in Normal configuration (see page 115)
The module has:




To connect Ekip CI to Ekip Touch, the Ekip Cartridge accessories (page 127) and Ekip Supply
accessories (page 130) are required.
Connections See:
Ekip CI is powered directly by the Ekip Supply module it is connected to.
Supply
Output The O61 output contact (K61 and K62), normally closed, is opened in case of a TRIP.
Re-closure is possible following a command to the Trip Reset input or, if the Autoreclosure
function is active, after the time defined by the user (Autoreclosure Time).
The contact has the following electrical characteristics:
Characteristics
Rated breaking capacity
Minimum breaking power
Insulation resistance between contact and Trip
unit
1SDH002031A1002 ECN000092998
A contact for controlling a contactor
An input for a PT100 temperature probe (2 wires)
A digital input for the Trip Reset function
LED indicating the module's power on status and the operation of the module

The 1SDM000068R0001 wiring diagrams for connection and terminal references. For
the I61 input use insulated cables for resistance thermometers like PENTRONIC
TEC/SITW-24F (TX type) or similar, with a maximum length of three meters

The kit sheet 1SDH002009A1503 to connect the module to Ekip Supply and Ekip M
Touch
IMPORTANT: the I61 input is not isolated: regardless of the system voltage, the
customer must ensure the insulation between the input and power supply of the
Ekip Supply module according to the application and grid
NOTE: without an auxiliary power supply the communication between Ekip M Touch
and module will be interrupted, the output contact maintains the status, the input signals
are no longer valid.
NOTE: data related to a resistive load
Rev. B
(NOTE)
Maximum limit
8A @ 250 VAC / 5A @ 30 VDC
10 mA @ 5 VDC
1000 MΩ, 50 VDC
SACE Tmax XT2 – XT4 | 178