ABB SACE Tmax XT2 User Manual page 190

Remote From the service connector (via Ekip Connect) or with communication by system bus it is possible
configurations to access additional parameters:
Parameter
Enable IEEE 1558
IEEE 1588 Master
IEEE 1588 Delay
mechanism
Enable client SNTP
SNTP Server Address
Time zone
Daylight Saving Time
Remote From the service connector (via Ekip Connect) or with a system bus communication, additional
information information can be accessed:
Information
HW and Boot version
Flash CRC status and result
Ekip Link status
SNTP Server Error
SNTP Server Synchronisation
IEEE 1558 status
1SDH002031A1002 ECN000092998
Description
Permits the IEEE 1588 protocol for distributing the clock
and synchronization signal to be enabled
Enables the module to be set as a master in the network
segment to which it belongs (synchronization clock)
Enables the data exchange mode between module and
master, between Peer-to-Peer and End-to-End to be
chosen
Permits enabling of SNTP distribution protocol of the
clock and synchronization signal
Enables the network server to be set that supplies SNTP
Defines the time zone to be used for synchronism
Enables it to be selected whether there is daylight
saving time(ON) or not (OFF) in the country to which the
synchronization time refers.
NOTE: Enable IEEE 1558 and Enable SNTP client must not be enabled simultaneously
Rev. B
(NOTE)
Description
general module information
information on the correctness of the SW in the module
Signals connection errors of the Ethernet cable
Communication error with the SNTP server
Synchronism status with SNTP server
Valid with IEEE 1588 Master = ON, communicates the
presence (Slave or PTP Master Active) or absence (PTP
Master but Passive) of a higher level master
Default
OFF
(NOTE)
OFF
End-to-
End
OFF
0.0.0.0
+00:00
OFF
SACE Tmax XT2 – XT4 | 190