Password And Security - ABB SACE Tmax XT2 User Manual

13 - Password and security

Function The password is intended to prevent unintentionally setting incorrect parameters
from the display.
However, changing parameters without entering the password is allowed from:
Safety
Description The password is a five-digit number, each of which can have a value from 0 to 9. The default
value is: 00001.
The password is required when:


Entering the password allows access to all menus without having to re-enter it repeatedly if the
operations are carried out within a time of two minutes. Once this time has elapsed it must be
entered again, where necessary.
Entering the To enter the password it is necessary to confirm each digit using the Enter button, changing the
password digit as needed with the Right/Up and Left/Down buttons. To confirm the entry of the password
it is therefore necessary to press Enter five times:
Figure 18
Disabling the You can disable the password by setting it to the value: 00000.
password In this situation the only action that will require entering the password is changing the password
itself, in the Settings menu.
Exceptions
1SDH002031A1002 ECN000092998

Service connector, with Ekip T&P or Ekip Programming and the Ekip Connect application

Bus, with Ekip Com modules and with the Trip unit configured Remote (page 29)
WARNING! it is suggested to set a password for the Ekip Connect and the remote
control system
WARNING! it is the user's responsibility to configure the security to prevent
unauthorized accesses and changes
Selecting a parameter to be changed (including the password itself, in the Settings menu)
Selecting the Test menu
NOTE: the password also expires when a programming session is canceled (page 31)
NOTES:

If the wrong password is entered, the message "Password incorrect" will appear
for about 3 seconds and the page for entering the password will re-open

There is no limit to the number of incorrect passwords that can be entered

If the password is lost, see the document 1SDH001501R0001 available on the
ABB website, or contact ABB directly
Rev. B
SACE Tmax XT2 – XT4 | 33