ABB SACE Tmax XT2 User Manual page 155

Remote From the service connector (via Ekip Connect) or with communication by system bus, it is
information possible to access additional information:
Information
HW and Boot version
Flash CRC status and result
Ekip Link status
SNTP Server Error
SNTP Server Synchronisation
IEEE 1558 status
GOOSE Missing
Configure Mismatch
Decode Error
Sequence number error
Remote programmable
statuses (from E to R)
Remote inputs of zone
selectivity
1SDH002031A1002 ECN000092998
Description
general module information
information on the correctness of the SW in the module
Signals connection errors of the Ethernet cable
Communication error with the SNTP server
Synchronism status with SNTP server
Valid with IEEE 1588 Master = ON, communicates the
presence (Slave or PTP Master Active) or absence (PTP
Master but Passive) of a higher level master
Signals whether an expected GOOSE has been received
A received GOOSE does not comply with the expected
structure
Condition (true/false) of the programmable statuses and
information on selectivity arising from logics defined in the
configuration files loaded on module IEC 61850
Rev. B
SACE Tmax XT2 – XT4 | 155