Spa Password; How To Select Language - ABB REM 610 Operator's Manual

1MRS755538
4.1.7.
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 4.1.7.-1 Changing SPA password
4.1.8.
Motor Protection Relay
Operator's Manual - ANSI version

SPA password

The password for SPA bus communication is required for altering parameter values
via the SPA bus. The default password is 001. You can change the SPA password
either via the HMI or the SPA bus by first entering the currently valid password into
parameter V160 and then entering the new password into parameter V161.
Change the SPA password as follows:
1. Press an arrow button to access the main menu
2. Use the arrow buttons to select CONFIGURATION\COMMUNICATION\SPA
SETTINGS\PASSWORD SPA and press
3. Press to enter the setting mode and give the current HMI password if
required. If the default password 999 is still valid, no password is required.
4. The first digit of the password to be edited starts to flash. Set the digit using
and .
5. Activate the next digit to be set by pressing
6. To store the new SPA password and return the display to the view mode, press
. The display confirms the storage by flashing "- - -" once on the display.
Alternatively, to exit the setting mode without storing the SPA password change,
press once before confirming and the display returns to the view mode.
7. Press to return the display to the idle mode.
Group Menu
CONFIGURATION
CONFIGURATION
FUNCTION TEST/DI
COMMUNICATION
LANGUAGE
MEMORY SETTINGS
FREQUENCY
HMI PASSWORDS
TIME
TRIP CIRCUIT SUP
RTD INPUTS
STORE COUNTER

How to select language

The relay allows you to choose among several different languages. The default
language is English.
Change the display language as follows:
Parameter Menus
REAR CONNECTION
REAR PROTOCOL
REAR COM. MODULE
SPA SETTINGS
IEC103 SETTINGS
MODBUS SETTINGS
UNIT ADDRESS :xxx
COUNTER :xxx
LINE-IDLE STATE
CONNECTION TYPE
.
or .
CONFIGURATION
Scroll for the digit
Confirm
PASSWORD SPA :xxx
Set the digit
REM 610 REM 610
Cancel
A040233_2
21