Table of Contents
Advertisement
5
Expanding Your Measurement Experience
Testing the Agilent 8663A Internal/External 10 MHz
Defining the
Measurement
5-12
E5500 Phase Noise Measurement System Version A.02.00
1
From the File menu in the E5500 User Interface, choose Open. If
necessary, choose the drive or directory where the file you want
is stored.
2
In the File Name box, choose "Conf_8663A_10MHz.pnm." See
Figure
5-12.
Figure 5-12 Select the Parameters Definition File
3
Click the Open button.
The appropriate measurement definition parameters for this
example have been pre-stored in this file.
parameter data that has been entered for this measurement
example.)
NOTE: Note that the source parameters entered for step 2 in
Table 5-4
may not be appropriate for the reference source you are
using. To change these values, refer to
step 4
below. Otherwise, go to
page 5-17:
4
Using
Figure 5-13
as a guide, navigate to the Sources tab.
a
Enter the carrier (center) frequency of your UUT (5 MHz to
1.6 GHz). Enter the same frequency for the detector input
frequency.
b
Enter the VCO (Nominal) Tuning Constant (see
c
Enter the Tune Range of VCO (see
d
Enter the Center Voltage of VCO (see
e
Enter the Input Resistance of VCO (see
Table 5-4
Table
5-2, then continue with
"Beginning the Measurement"
Table
5-2).
Table
5-2).
Table
Document Part No. E5500-90024 Ed. 1.0
lists the
on
Table
5-2).
5-2).
Advertisement
Table of Contents
