Table of Contents
Advertisement
7
Absolute Measurement Examples
Microwave Source
Checking the
Beatnote
7-76
E5500 Phase Noise Measurement System Version A.02.00
Figure 7-51 Connect Diagram for the Microwave Source Measurement
4
Refer to the following system connect diagram examples in
Chapter
18, "Connect Diagrams" of this document for more
information about system interconnections. That chapter also
contains additional examples.
G
Figure
18-9, "E5503A Opt. 001 Connect Diagram," on
page 18-11
G
Figure
18-21, "E5503B Opt. 001 Connect Diagram," on
page 18-23
G
Figure
18-13, "E5504A Opt. 201 Connect Diagram," on
page 18-15
G
Figure
18-25, "E5504B Opt. 201 Connect Diagram," on
page 18-27
While the connect diagram is still displayed, recommend that you use
an oscilloscope (connected to the Monitor port on the Agilent
70420A) or a counter to check the beatnote being created between
the reference source and your device-under-test. The objective of
Document Part No. E5500-90024 Ed. 1.0
Advertisement
Table of Contents
