7
Absolute Measurement Examples
RF Synthesizer using EFC
Beginning the
Measurement
7-58
E5500 Phase Noise Measurement System Version A.02.00
1
From the Measurement menu, choose New Measurement. See
Figure 7-40
.
Figure 7-40 Selecting a New Measurement
2
When the Perform a New Calibration and Measurement?
prompt appears, click OK.
3
When the Connect Diagram dialog box appears, click on the
hardware down arrow and select your hardware configuration
from the pull-down list.
Confirm your connections as shown in
connect your UUT and reference sources to the test set. The input
attenuator (Option 001 only) has now been correctly configured
based on your measurement definition.
CAUTION:
The Agilent 70420A test set's signal input is subject to the
following limits and characteristics:
Figure
7-41. At this time,
Document Part No. E5500-90024 Ed. 1.0