Table of Contents
Advertisement
Safety summary
Document Part No. E5500-90024 Ed. 1.0
The following general safety
precautions must be observed
during all phases of operation of
this instrument. Failure to
comply with these precautions
or with specific warnings
elsewhere in this manual
violates safety standards of
design, manufacture, and
intended use of the instrument.
Agilent Technologies, Inc.
assumes no liability for the
customer's failure to comply
with these requirements.
General
This product is a Safety Class 1
instrument (provided with a
protective earth terminal). The
protective features of this
product may be impaired if it is
used in a manner not specified
in the operation instructions.
All light emitting diodes (LEDs)
used in this product are Class 1
LEDs as per IEC 60825-1.
WARNING:
DO NOT OPERATE
IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the
presence of flammable gases or
flames.
E5500 Phase Noise Measurement System Version A.02.00
WARNING:
DO NOT REMOVE
THE INSTRUMENT COVER
Operating personnel must not
remove instrument covers.
Component replacement and
internal adjustments must be made
only by qualified service personnel.
Instruments that appear damaged or
defective should be made
inoperative and secured against
unintended operation until they can
be repaired by qualified service
personnel.
Environmental conditions
Unless otherwise noted in the
specifications, this instrument
or system is intended for indoor
use in an installation category
II, pollution degree 2
environment. It is designed to
operate at a maximum relative
humidity of 95% and at altitudes
of up to 2000 meters. Refer to
the specifications tables for the
ac mains voltage requirements
and ambient operating
temperature range.
Before applying power
Verify that the product is set to
match the available line voltage,
the correct fuse is installed, and
all safety precautions are taken.
Note the instrument's external
markings described in
Table
1.
iii
Advertisement
Table of Contents
