Table of Contents
Advertisement
13
AM Noise Measurement Examples
AM Noise using an Agilent 70420A Option 001
Beginning the
Measurement
13-8
E5500 Phase Noise Measurement System Version A.02.00
15 When you have completed these operations, click the Close
button.
1
From the Measurement menu, choose New Measurement See
Figure 13-8
.
Figure 13-8 Selecting a New Measurement
2
When the Perform a New Calibration and Measurement?
prompt appears, click OK.
3
When the Connect Diagram dialog box appears, click on the
hardware down arrow and select your hardware configuration
from the pull-down list. See
Confirm your connections as shown in the connect diagram. At
this time connect your UUT and reference sources to the test set.
The input attenuator (Option 001 only) has now been correctly
configured based on your measurement definition.
CAUTION:
The Agilent 70420A test set's signal input is subject to the
following limits and characteristics:
Figure 13-9
Document Part No. E5500-90024 Ed. 1.0
Advertisement
Table of Contents
