Table of Contents
Advertisement
Document Part No. E5500-90024Ed. 1.0
Figure 5-23 Select the Parameters Definition File
3
Click the Open button.
The appropriate measurement definition parameters for this
example have been pre-stored in this file.
parameter data that has been entered for the RF Synthesizer
using DCFM measurement example.)
NOTE: Note that the source parameters entered for step 2 in
Table 5-8
may not be appropriate for the reference source you are
using. To change these values, refer to
withstep 4
below. Otherwise, go to
page 5-34:
4
Using
Figure 5-24
as a guide, navigate to the Sources tab
a
Enter the carrier (center) frequency of your UUT (5 MHz to
1.6 GHz). Enter the same frequency for the detector input
frequency.
b
Enter the VCO (Nominal) Tuning Constant (see
c
Enter the Tune Range of VCO (see
d
Enter the Center Voltage of VCO (see
e
Enter the Input Resistance of VCO (see
E5500 Phase Noise Measurement System Version A.02.00
Expanding Your Measurement Experience
Testing the Agilent 8644B Internal/External 10 MHz
Table 5-8
Table
5-6, then continue
"Beginning the Measurement"
Table
Table
5
lists the
on
Table
5-6).
5-6).
5-6).
Table
5-6)
5-29
Advertisement
Table of Contents
