9
Residual Measurement Examples
Amplifier Measurement Example
Beginning the
Measurement
9-8
E5500 Phase Noise Measurement System Version A.02.00
1
From the View menu, choose Meter to select the quadrature
meter. See
Figure
9-8.
Figure 9-8 Select Meter from View Menu
1
From the Measure menu, choose New Measurement. See
Figure
9-9.
Figure 9-9 Selecting a New Measurement
2
When the Perform a New Calibration and Measurement?
prompt appears, click OK.
3
When the Connect Diagram dialog box appears, click on the
hardware down arrow and select your hardware configuration
from the pull-down list. Refer
Confirm your connections as shown in the connect diagram. At
this time connect your UUT and reference sources to the test set.
The input attenuator (Option 001 only) has now been correctly
configured based on your measurement definition.
toFigure
9-10.
Document Part No. E5500-90024 Ed. 1.0