At&W Stores Current Configuration To User Defined Profile - Siemens TC35i User Manual

TC35i AT Command Set
2.3 AT&W
2.3 AT&W Stores current configuration to user defined profile
Syntax
Exec Command
AT&W [ ]
<value>
Response(s)
OK
ERROR/+CME ERROR <err>
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
TA stores the currently set parameters to a user defined profile in the non-volatile memory.
Parameter Description
(num)
<value>
[0]
Notes
• The user defined profile will be restored automatically after PowerUp. Use
to restore factory settings. Until the first use of
AT&F
• User defined profiles in multiplex mode:
stores the current setting of each channel to the user profile, no matter on which of the three channels
AT&W
the command is executed. Each channel may have an individual profile.
• A list of parameters stored to the user profile can be found in Chapter
.
with AT&W
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
Number of profile
Page 32 of 439
ATZ
, works as
AT&W ATZ AT&F
AT Command Settings storable
s
m
obile
to restore user profile and
.
1/30/04