TC35i AT Command Set
15.15 AT^SNFS
15.15
AT^SNFS Select audio hardware set
Syntax
Test Command
AT^SNFS=?
Response(s)
^SNFS: (list of supported
OK
Read Command
AT^SNFS?
Response(s)
^SNFS:
<audMode>
OK
Write Command
AT^SNFS=<audMode>
Response(s)
OK
ERROR
CME ERROR: <err>
PIN
ASC0
MUX1
!
%
%
Reference(s)
SIEMENS
Command Description
The write command serves to set the audio mode required for the connected equipment. For use after restart of
the module, you are advised to store the selected mode to the audio profile set with
mode 1 will be active each time the module is powered up.
can also be used in conjunction with
AT^SNFS
ated alternatively to benefit from different devices. Each audio mode can be assigned a specific interface. To do
so, first select the audio mode with
to store the settings to your audio profile. To switch back and forth it is sufficient to use
AT^SNFW
TC35i_ATC_V02.07
Confidential / Released
s)
<audMode>
MUX2
MUX3
%
%
AT^SAIC
, then activate the audio interface with
AT^SNFS
Page 385 of 439
. This is useful, for example, if both interfaces are oper-
s
m
obile
. Otherwise, audio
AT^SNFW
and finally enter
AT^SAIC
.
AT^SNFS
1/30/04