Ath Disconnect Existing Connection - Siemens TC35i User Manual

TC35i AT Command Set
7.8 ATH
7.8

ATH Disconnect existing connection

Syntax
Exec Command
ATH [ ]
<n>
Response(s)
OK
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
Disconnect existing call from command line by local TE and terminate call.
Parameter Description
(num)
<n>
[0]
Notes
• OK is issued after circuit 109 (DCD) is turned off, if it was previously on.
• terminates every circuit switched call (voice, data or fax), even if it is issued via another interface. This
ATH
behavior is in accordance with ITU-T V.25 ter; (07/97, "Hook control": "
progress.").
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
disconnect from line and terminate call
Page 154 of 439
s
m
obile
is terminating any call in
ATH
1/30/04