Configuration Commands; At&F Set All Current Parameters To Manufacturer Defaults - Siemens TC35i User Manual

TC35i AT Command Set

2. Configuration Commands

2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the TC35i's behaviour
under various conditions.
2.1 AT&F Set all current parameters to manufacturer defaults
Syntax
Exec Command
AT&F [ ]
<value>
Response(s)
OK
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
TA sets all current parameters to the manufacturer defined profile.
Parameter Description
(num)
<value>
[0]
Notes
• List of parameters reset to manufacturer default can be found in Chapter
Restorable with AT&F
• In addition to the default profile, you can store an individual one with
files enter either
ATZ
• Every ongoing or incoming call will be terminated.
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
set all TA parameters to manufacturer defaults
.
(loads user profile) or
AT&F
Page 28 of 439
. To alternate between the two pro-
AT&W
(restores factory profile).
s
m
obile
Factory Default Settings
1/30/04