Introduction; Scope Of The Document; Table 1.1: Product Specific Use Of At Commands - Siemens TC35i User Manual

TC35i AT Command Set

1. Introduction

1. Introduction
1.1

Scope of the document

This document presents the AT Command Set for the Siemens Cellular Engines
TC35i Version 02.07
TC35i Terminal Version 02.07.
Before using the Cellular Engine or upgrading to a new firmware version please read the latest product informa-
tion provided in the Release Notes [1].
More information is available at the Siemens Website: http://www.siemens.com/wm.
If features differ between TC35i and TC35i Terminal this is noted in the section that refers to the AT command.
At present the following features are concerned:
Table 1.1: Product specific use of AT commands
AT command
AT+ILRR
AT+IPR
AT+CALA
AT^SAIC
AT^SSYNC
AT^SBC
TC35i_ATC_V02.07
Confidential / Released
Module version
Maximum bit rate: 230400 bps
Maximum bit rate: 230400 bps
Alarm mode and reminder message fully
applicable
All parameters usable as described.
SYNC pin may be assigned different
functions: 0 , 1 or 2.
<mode>
All functions fully applicable
Page 12 of 439
s
Terminal version
Maximum bit rate: 115200 bps
Maximum bit rate: 115200 bps
Does not support Alarm mode. Please
ignore any information relating to the
subject.
The reminder message can be used as
described.
Additional recommendations for using
audio modes 2, 3 and 6 with TC35i Ter-
minal.
SYNC pin supports only
<mode>
(LED status)
Command not applicable
m
obile
=1 or 2.
1/30/04